Setup lab · 3.5" Pi Zero screen
Set up the 3.5" screen on a Raspberry Pi Zero
Run the one-line installer for the model printed on your screen, restart, then check the picture, touch and brightness knob — the same steps as our MZP351HV00BR guide, on a simulated Pi Zero 2 W with the screen attached.
- Raspberry Pi Zero 2 W
- iUniker 3.5" screen (MZP351HV00BR_2025), soldered on
- Raspberry Pi OS (64-bit) written with Raspberry Pi Imager
- SSH from your computer, HDMI unplugged
- Board
- Pi Zero 2 W
- Screen label
- MZP351HV00BR_2025
- Display setup
- Not installed
- Picture
- Backlight only
- Touch
- Not tried
- Brightness knob
- Not tried
Check the board and OS
The screen is already soldered onto a Raspberry Pi Zero 2 W, and Raspberry Pi OS was written with Raspberry Pi Imager with Wi-Fi and SSH turned on. The LCD shows only its backlight until the setup is done, so you’re connected over SSH with HDMI unplugged.
First confirm the board and the OS: Pi Zero and Zero W need 32-bit Raspberry Pi OS; Zero 2 W can run 32- or 64-bit.
cat /proc/device-tree/modelgetconf LONG_BIT
Run the installer for your screen’s label
Check the picture, touch and brightness
See what the installer changed (optional)
This follows our written setup guide. The installer was run for real on Raspberry Pi OS (2026-10-06): its messages, the config.txt changes and the backups shown here are what it printed. The screen itself, touch and the knob are simulated. The installer is an engineering preview tested on a Pi Zero 2 W — the guide on our wiki has its current status.