Setup labs
Try the setup before you buy
Some accessories need a few commands to set up. Each lab gives you a simulated Raspberry Pi terminal and walks you through them, step by step.
- NVMe HAT V2
Boot Raspberry Pi 5 from NVMe with the NVMe HAT V2
Turn on PCIe, check the SSD is detected, set the bootloader, write Raspberry Pi OS to the SSD and boot from it — the same steps as our INV001 guide, typed into a simulated Raspberry Pi 5.
- 3.5" Pi Zero screen
Set up the 3.5" screen on a Raspberry Pi Zero
Run the one-line installer for the model printed on your screen, restart, then check the picture, touch and brightness knob — the same steps as our MZP351HV00BR guide, on a simulated Pi Zero 2 W with the screen attached.
- PiTower
Set up the PiTower OLED and power button
Install the small service that drives the OLED and the power button, switch on I2C bus 0 and restart — then watch the stats come up and shut the Pi down from the button. The case’s real setup steps, on a simulated Raspberry Pi 5 inside it.
- PoE+ and NVMe HAT
Power a Raspberry Pi 5 over Ethernet and boot it from NVMe
This lab is on its way, along with the product. Until then, the written guide is on our wiki.
- 3.51" Pi Zero screen
Set up the 3.51" DPI screen on a Raspberry Pi Zero
This lab is on its way, along with the product. Until then, the written guide is on our wiki.