New · PiTower for Raspberry Pi 5 — OLED + triple RGB fansSee it

Setup lab · PiTower

Set up the PiTower OLED and power button

Install the small service that drives the OLED and the power button, switch on I2C bus 0 and restart — then watch the stats come up and shut the Pi down from the button. The case’s real setup steps, on a simulated Raspberry Pi 5 inside it.

Simulated setup
  • PiTower with a Raspberry Pi 5 (8 GB) inside
  • 512 GB NVMe SSD running Raspberry Pi OS Desktop
  • 5V 5A USB-C power supply
About the PiTower Elecrow setup guide
Step 1 of 5
Setup files
Not yet
Python libraries
Installed
OLED service
Not set up
Power-off service
Not set up
I2C bus 0
Off
Power button
Not tried
  1. Get the setup files

    The PiTower is assembled around a Raspberry Pi 5 that boots Raspberry Pi OS from an NVMe SSD, on a 5V 5A USB-C supply. The fans run already; the OLED stays dark until its service is installed.

    The setup files are on GitHub. Update the package lists, make sure git is installed, and clone them into your home folder.

    • sudo apt update
    • sudo apt install -y git
    • git clone https://github.com/Elecrow-RD/Small-Mini-PC-Case.git
  2. Copy the files into place

  3. Install the libraries and start the services

  4. Switch on I2C bus 0 and restart

  5. Check the OLED and the power button

PiTower front panelFans on, OLED dark (setup not finished)The power button works like the real one
pi@raspberrypi: ~Simulated
Type hint for help · Tab completes

This follows the setup guide from Elecrow, who make this case. Elecrow’s files and commands were run on a real Raspberry Pi OS (2026-10-06) system and the output here is what they printed. The OLED, fans, power button and I2C bus need the case itself, so those are simulated.