New · PiTower for Raspberry Pi 5 — OLED + triple RGB fansSee it

Setup lab · NVMe HAT V2

Boot Raspberry Pi 5 from NVMe with the NVMe HAT V2

Turn on PCIe, check the SSD is detected, set the bootloader, write Raspberry Pi OS to the SSD and boot from it — the same steps as our INV001 guide, typed into a simulated Raspberry Pi 5.

Simulated setup
  • Raspberry Pi 5
  • iUniker NVMe HAT V2 (INV001)
  • 512 GB M-Key NVMe SSD
  • Raspberry Pi OS Desktop on microSD
About the NVMe HAT V2 INV001 setup guide
Step 1 of 9
PCIe
Off
SSD
Not detected yet
Boot order
0xf461
Runs from
microSD card
  1. Turn on PCIe

    The NVMe HAT V2 is a standard (non-HAT+) PCIe board, so Raspberry Pi OS only looks for it once PCIe is switched on. Open config.txt, add dtparam=pciex1 on its own line at the end, save with Ctrl+O and exit with Ctrl+X. Then restart.

    • sudo nano /boot/firmware/config.txt
    • sudo reboot

    Prefer a one-liner? echo "dtparam=pciex1" | sudo tee -a /boot/firmware/config.txt makes the same change.

  2. Check the SSD is detected

  3. Update Raspberry Pi OS and the bootloader

  4. Set the boot order

  5. Make sure you’re still on microSD

  6. Write Raspberry Pi OS to the SSD

  7. Boot from NVMe

  8. Measure the speed (optional)

  9. Try PCIe Gen 3 (optional, advanced)

pi@raspberrypi: ~Simulated
Type hint for help · Tab completes

This follows our written setup guide. Software output — apt, config.txt, Imager, the bundled bootloader version and settings — was recorded on a real Raspberry Pi OS (2026-10-06) system. Anything that needs the hardware — lspci, lsblk, flashing the bootloader, booting from NVMe, speeds — is simulated and varies with your Pi and SSD.